Neu im Onlineshop www.mikrocontroller-praxis.de
Eingabesysteme
SMALL SEALED MEMBRANE 4X3 BUTTON PAD WITH STICKER
Folientastatur, 4x3 Taster
This is a small new four by three matrix twelve key membrane switch keypad that is easy to use and will look nice in your project.It is very useful if you need it for prototyping with a breadboard or just need a keypad for your project.
SEALED MEMBRANE 4X4 BUTTON PAD WITH STICKER
Folientastatur, 4x4 Taster
This is a new four by four matrix sixteen key membrane switch keypad that is easy to use and will look nice in your project.It is very useful if you need it for prototyping with a breadboard or just need a keypad for your project.
SEALED MEMBRANE 4X3 BUTTON PAD WITH STICKER
Folientastatur, 4x3 Taster
This is a new four by three matrix twelve key membrane switch keypad that is easy to use and will look nice in your project.It is very useful if you need it for prototyping with a breadboard or just need a keypad for your project.
JOYSTICK BREAKOUT MODULE
2 analoge Kanäle + Button
The joystick on this module is very similar to the 'analog' joysticks on PS2 (PlayStation 2) controllers. Directional movements are simply two potentiometers - one for each axis. Pots are ~10k each. This joystick also has a select button that is actuated when the joystick is pressed down. There are 5 pins on board: VCC, GND, X, Y and Button. Connect the module with 5V power suppy with VCC and GND, you can read out the joystick status by X,Y and button pins.
ELECTRONIC BRICK - ROTARY POTENTIOMETER BRICK
The potentiometer brick produces analog output between 0 and Vcc (5V DC with Seeeduino) on its D1 connector. The D2 connector is not used. The angular range is 300 degrees with a linear change in value. The resistance value is 10k ohms, perfect for Arduino use. This may also be known as a rotary angle sensor.
Arbeitsplatz + Entwicklung
COLOR BREADBOARD TRANSPARENT 700
This is a breadboard with 700 tie points. There are 5 available colors. It measures 17.6cmx4.6cm.
Verbindungstechnik
3 PIN DUAL-FEMALE JUMPER WIRE - 20CM
This is a simple 3-pin wire cable and usually connected to electronic bricks or modules which have standard 0.1" breakaway male headers. And its 3-pin interface is the same as normall plane servo connector.
4 PIN DUAL-FEMALE JUMPER WIRE - 20CM (PARALLEL)
This is a simple Parallel 4-pin wire cable which can be used to connect some electronic bricks or modules with sensor shield.
1 PIN DUAL-FEMALE JUMPER WIRE - 100MM (50PCS PACK)
This is a pack including 50pcs 100mm dual-female DuPont jumpers. It includes 5 colors jumper wires, 10 pcs for each color. They work great with breadboards, Arduinos, and really any 0.1" pitch prototyping board.
1 PIN DUAL-MALE BREADBORAD JUMPER WIRE (65PCS PACK)
This is an upgraded pack including 65pcs dual-male jumpers. It includes 4 different length:
250mm 49pcs , 200mm 8pcs, 150mm 4pcs, 100mm 4pcs
They are perfect for solderless breadboards, Arduinos. This pack of 75 jumper wires will be a random assortment of various colors.
1 PIN DUAL-FEMALE JUMPER WIRE - 300MM (20PCS PACK)
This is a pack including 20pcs 300mm dual-female DuPont jumpers. It includes 4 colors jumper wires, 5 pcs for each color. They work great with breadboards, Arduinos, and really any 0.1" pitch prototyping board.
Eingabesysteme
SMALL SEALED MEMBRANE 4X3 BUTTON PAD WITH STICKER
Folientastatur, 4x3 Taster
This is a small new four by three matrix twelve key membrane switch keypad that is easy to use and will look nice in your project.It is very useful if you need it for prototyping with a breadboard or just need a keypad for your project.
SEALED MEMBRANE 4X4 BUTTON PAD WITH STICKER
Folientastatur, 4x4 Taster
This is a new four by four matrix sixteen key membrane switch keypad that is easy to use and will look nice in your project.It is very useful if you need it for prototyping with a breadboard or just need a keypad for your project.
SEALED MEMBRANE 4X3 BUTTON PAD WITH STICKER
Folientastatur, 4x3 Taster
This is a new four by three matrix twelve key membrane switch keypad that is easy to use and will look nice in your project.It is very useful if you need it for prototyping with a breadboard or just need a keypad for your project.
JOYSTICK BREAKOUT MODULE
2 analoge Kanäle + Button
The joystick on this module is very similar to the 'analog' joysticks on PS2 (PlayStation 2) controllers. Directional movements are simply two potentiometers - one for each axis. Pots are ~10k each. This joystick also has a select button that is actuated when the joystick is pressed down. There are 5 pins on board: VCC, GND, X, Y and Button. Connect the module with 5V power suppy with VCC and GND, you can read out the joystick status by X,Y and button pins.
ELECTRONIC BRICK - ROTARY POTENTIOMETER BRICK
The potentiometer brick produces analog output between 0 and Vcc (5V DC with Seeeduino) on its D1 connector. The D2 connector is not used. The angular range is 300 degrees with a linear change in value. The resistance value is 10k ohms, perfect for Arduino use. This may also be known as a rotary angle sensor.
Arbeitsplatz + Entwicklung
COLOR BREADBOARD TRANSPARENT 700
This is a breadboard with 700 tie points. There are 5 available colors. It measures 17.6cmx4.6cm.
Verbindungstechnik
3 PIN DUAL-FEMALE JUMPER WIRE - 20CM
This is a simple 3-pin wire cable and usually connected to electronic bricks or modules which have standard 0.1" breakaway male headers. And its 3-pin interface is the same as normall plane servo connector.
4 PIN DUAL-FEMALE JUMPER WIRE - 20CM (PARALLEL)
This is a simple Parallel 4-pin wire cable which can be used to connect some electronic bricks or modules with sensor shield.
1 PIN DUAL-FEMALE JUMPER WIRE - 100MM (50PCS PACK)
This is a pack including 50pcs 100mm dual-female DuPont jumpers. It includes 5 colors jumper wires, 10 pcs for each color. They work great with breadboards, Arduinos, and really any 0.1" pitch prototyping board.
1 PIN DUAL-MALE BREADBORAD JUMPER WIRE (65PCS PACK)
This is an upgraded pack including 65pcs dual-male jumpers. It includes 4 different length:
250mm 49pcs , 200mm 8pcs, 150mm 4pcs, 100mm 4pcs
They are perfect for solderless breadboards, Arduinos. This pack of 75 jumper wires will be a random assortment of various colors.
1 PIN DUAL-FEMALE JUMPER WIRE - 300MM (20PCS PACK)
This is a pack including 20pcs 300mm dual-female DuPont jumpers. It includes 4 colors jumper wires, 5 pcs for each color. They work great with breadboards, Arduinos, and really any 0.1" pitch prototyping board.